You can set Standby Modes with a SCS Controller to intelligently reduce your cooler’s power use. Find out more in this article about the specific parameters for lighting.
Light State Standby Mode - Channel A, B, C, D*, E* (LSA, LSb, LSC, LSd, LSE)
Control lighting levels in your coolers with up to 5 lighting modes (LSA, LSb, LSC, LSd, and LSE) that adjust the illumination levels of connected lighting during Standby Mode (as a percentage of full illumination).
Light levels of between 0% and 100% are only available if the lighting channel is assigned to an LED output light. If assigned to a digital output, then any level other than 0% will result in 100% illumination level.
| Digital display | Increments & units | Parameter range | Default |
|
1% | 0 to 100 | 0% |
*Channel D and E are only supported by these SCS Controller models - SCS Adv and SCS Adv No Display.
Marketing Mode
Selects whether or not the lights stay on at all times.
- off = Light levels and effects controlled by the current mode settings
- on = Light levels and effects during Transition and Standby Modes controlled by Normal Mode settings
- c01 = Custom Setting 01. All 3 LED lighting channels cycle continuously from 0 to 100%. Used for RGB lighting to cycle colours. Door state and mode is ignored
- c02 = Custom Setting 02. Lighting is adjusted based on return-air-temp and door status
| Digital display | Increments & units | Parameter range | Default |
| tnG | text | on or off | off |